In this episode I work on the disassembly, measurement and recording of details for the Typhoon's aileron pulley bracket. Without complete drawings, this is an area in the cockpit that we must rely on surviving parts to either reuse or reverse engineer. Fortunately we have two fair condition assemblies from which to choose from.
Up Next in Season 1
-
S1E13 Solution Heat Treating Explaine...
In this episode I was delighted to work with the team at Pyrotek Aerospace Ltd. in Abbotsford British Columbia to run through the process of taking our Typhoon forward monocoque frame segments from "O" condition through to T42. Solution heat treating is a very important part of the process to ret...
-
Episode 15 Hawker Typhoon- Fitting Fu...
In this episode, I run through the procedure for trimming, fitting and finishing the fuselage frame segments, getting them ready for the production and installation of splice plates.
-
S01E16 Hawker Typhoon Rebuild - Monoc...
This episode details the work I've been doing to build a tooling system to produce the small, complicated splice plates used to join the frame segments in the Hawker Typhoon forward monocoque section. With the tooling done and proven, I'm able to take you through the production of one plate from ...
2 Comments